Abstract
Crude terephthalic acid (CTA) as a chemical compound is used for flooding here as an alternative to the traditional hydrolyzed polyacrylamide (HPAM) because of its availability and economical aspects and higher efficiency. Crude oil samples from an Iranian oil field were used during the flooding tests. Sand packed models using two different sizes of sand mainly 50 and 100 meshes were employed in this investigation. A comparison between water flooding and CTA flooding as a secondary oil recovery process revealed that the oil recovery factor was improved by 10% OOIP when CTA after water flooding was used in secondary state. The effect of various injection rates and different concentration of chemical solutions on the recovery factor have been checked. Besides, experimental results improved the surfactant behavior of the CTA solution in water. Experiments showed that oil recovery factor increased by 5% OOIP when SDS solution was used in tertiary state. Experiments were performed in laboratory temperature and pressure around 10 bars.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
