Abstract

Carbon dioxide (CO2) as energized fluid has been used for acid-fracturing in tight carbonate reservoir. CO2 is often pumped into the wellbore in liquid phase with acid systems, and transited into supercritical state under the high-temperature formation. While the effect of supercritical CO2 (SC-CO2) on acid-etched fracture morphology and conductivity have rarely been investigated. The acid-etching and conductivity experiments were conducted on the outcrops of the Ma5 sub-member of the Ordo Basin in China. The mixed phase reaction simulation device was developed firstly. These experiments involved the mixing of SC-CO2 with various fluids, including formation water and viscoelastic surfactant (VES) acid, as well as different SC-CO2 concentrations with VES acid. The results show that 100 % SC-CO2 is easy to activate natural fractures without dissolution. After 20%SC-CO2 mixed with formation water, the dissolution ability of the mixed solution and conductivity is only 11.8 % and 1 ∼ 2 % of VES acid respectively. Roughness of the morphology created by the mixture of SC-CO2 with VES acid, exhibits a reduction compared to VES acid-etching, accompanied by the presence of wormholes. Additionally, there is a decrease in conductivity and increase in its retention rate. With the increase of SC-CO2 concentration, the roughness of acid-etching fracture decrease and the injection pressure curve becomes more stable. While the reaction rate is also retarded nearly linearly as the SC-CO2 concentration increases. Especially, when the SC-CO2 concentration is up to 40 %, the acid-rock reaction rate reaches only 55 % of that of VES acid. The conductivity of mixed-acid-etched fracture exhibits a segmented characteristic. During the low-medium closure pressure stage, the acid-etched fracture by VES acid generates high conductivity, specifically when it is below 34.5 MPa. While the higher the SC-CO2 concentration in the mixed acid is, the greater the conductivity and retention rate are at pressures above 34.5 MPa during high closure pressure stage. The conductivity of SC-CO2 acid-fracturing fracture depends on the non-uniform etching of the acid solution. The increase in SC-CO2 concentration of the mixed acid not only enhances conductivity and retention rate under high closure pressure, but also reduces the acid volume required for acid-fracturing.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call