Experimental investigation of the compressive and shear resistance of laminated steel-reinforced glass beams

Abstract

This paper presents an experimental investigation into the compressive and shear resistance of triple-layered laminated steel-reinforced glass beams. Two types of tests are performed: (a) local compressive tests (force over a support) and (b) bending tests (force close to a support). In total, six local compressive tests and eight bending tests are performed. Overall, beams with a shear span-to-effective depth ratio (a/d) approximately equal to 0, 0.63, and 1.0 are tested. Two different types of flexural reinforcement are used separately: solid (S) and hollow (H) reinforcement. The behaviour of the outer glass panes, and top and bottom reinforcement is monitored using strain gauges and Digital Image Correlation (DIC). The test results are elaborated in terms of load-displacement curves, the evolution of strains and crack patterns. Three failure modes are observed: yielding of the reinforcement (PF), crushing of glass (CF), and rupture of the reinforcement (RR). Shear failure occurred due to the crushing of glass in the compressed diagonal strut in the shear span. It was found that the shear resistance increases with a smaller shear span-to-effective depth ratio and stronger reinforcement. The dominant shear transfer mechanism was the direct strut action. It was found that the post-fracture capacity had a relatively constant value for all the tests with a slight increase for smaller a/d. The actual tensile strains in the bottom reinforcement measured by DIC are compared with the calculated strains based on the curvature of uncracked and cracked cross-sections, assuming plane section behaviour. It was observed that the actual strains are systematically larger than the calculated ones because, in reality, the section does not remain plane. After the appearance of the first crack, the beams essentially behave like strut-and-tie systems, where the strut is the diagonally compressed laminated glass and the tie is the bottom reinforcement.