Abstract
In this investigation, the effects of input parameters of wire electrical discharge machining (WEDM) process such as pulse current and pulse duration on recast layer thickness (RLT) and heat affected zone depth (HAZ) in machining of Inconel 617 was investigated. Also the corrosion behavior of the machined workpiece was studied. The results showed that RLT increased by increasing pulse current, while HAZ decreased after an increase up to 10 A. Recast layer thickness and HAZ increased by increasing pulse duration. Also, results suggest that WEDM increased the corrosion resistance of workpiece.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
