Experimental investigation of low velocity and high temperature solid particle impact erosion wear

Abstract

Next generation Concentrating Solar Power (CSP) plants utilizing solid particles as the heat transfer medium (HTM) are expected to achieve greater operational efficiencies. However, the erosion from the solid particles can cause significant damage to component materials. Low particle speeds (1–2 m/s) are proposed as a means of preventing excessive damage to containment materials. Within the current investigation, solid particle erosion of three potential containment materials, stainless-steel grade 316L, a nickel alloy (Inconel 740H), and a refractory material (Tufcrete 60 M), are examined at a particle impact speed of 1.6 m/s. CarboBead-HSP 40/70 particles, a candidate HTM for CSP systems, impact the specimens at a relatively high impact angle of 60° based on containment design criteria. Experiments were conducted at ambient temperature and 800 °C to examine erosion of the materials at very low impact speeds and determine how temperature effects erosion. Initial results revealed surprising outcomes inconsistent with available literature: ambient temperature erosion of SS316L is an order of magnitude lower than IN740H, but erosion (erosion-corrosion) of SS316L at 800 °C surpasses IN740H by two orders of magnitude. Results suggest removal of oxide layers (erosion-corrosion) is responsible for the significant erosion that was observed even at these low particle speeds.