Abstract
This paper presents an experimental investigation of laminar gas flow through microchannels. The independent variables: relative surface roughness, Knudsen number and Mach number were systematically varied to determine their influence on the friction factor. The microchannels were etched into silicon wafers, capped with glass, and have hydraulic diameters between 5 and 96 μm. The pressure was measured at seven locations along the channel length to determine local values of Knudsen number, Mach number and friction factor. All measurements were made in the laminar flow regime with Reynolds numbers ranging from 0.1 to 1000. The results show close agreement for the friction factor in the limiting case of low Ma and low Kn with the incompressible continuum flow theory. The effect of compressibility is observed to have a mild (8 percent) increase in the friction factor as the Mach number approaches 0.35. A 50 percent decrease in the friction factor was seen as the Knudsen number was increased to 0.15. Finally, the influence of surface roughness on the friction factor was shown to be insignificant for both continuum and slip flow regimes.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
