Abstract

PurposeThe purpose of this study is to experimentally investigate the trends in shock wave Mach number that were observed when different diaphragm material combinations were used in the small-scale shock tube.Design/methodology/approachA small-scale shock tube was designed and fabricated having a maximum Mach number production capacity to be 1.5 (theoretically). Two microphones attached in the driven section were used to calculate the shock wave Mach number. Preliminary tests were conducted on several materials to obtain the respective bursting pressures to decide the final set of materials along with the layered combinations.FindingsAccording to the results obtained, 95 GSM tracing paper was seen to be the strongest reinforcing material, followed by 75 GSM royal executive bond paper and regular 70 GSM paper for aluminium foil diaphragms. The quadrupled layered diaphragms revealed a variation in shock Mach number based on the position of the reinforcing material. In quintuple layered combinations, the accuracy of obtaining a specific Mach number was seen to be increasing. Optimization of the combinations based on the production of the shock wave Mach number was carried out.Research limitations/implicationsThe shock tube was designed taking maximum incident shock Mach number as 1.5, the experiments conducted were found to achieve a maximum Mach number of 1.437. Thus, an extension to further experiments was avoided considering the factor of safety.Originality/valueThe paper presents a detailed study on the effect of change in the material and its position in the layered diaphragm combinations, which could lead to variation in Mach numbers that are produced. This could be used to obtain a specific Mach number for a required study accurately, with a low-cost setup.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call