Experimental investigation of corium quenching at elevated pressure

Abstract

This paper describes the results of experiments designed to quantify the cooling rate of corium by an overlying water pool. The experiments are intended to provide fundamental information on the ability of water to ingress into cracks and fissures that form in the debris during quench, thereby augmenting the otherwise conduction-limited heat transfer process. This information is being used to assess the effectiveness of a water pool in thermally stabilizing a molten-core/concrete interaction and cooling of ex-vessel core debris. The experiments involved corium inventories of 75 kg with a melt depth of 15 cm and diameter of 30 cm. The corium was composed of UO 2/ZrO 2/concrete to simulate mixtures of molten reactor core components and either siliceous or limestone/common sand (LCS) concrete. Initial melt temperatures were of the order of 2100 °C. The heat transfer rate from the corium was determined through measurements of the vapor production rate from the water pool. The melt was quenched at atmospheric pressure for the first two tests and at 4 bar for the two subsequent tests. Preliminary data analysis indicates that the overall heat transfer rate exceeded the conduction-limited rate for the three melts containing 8 wt.% concrete, but not for the fourth, which had 23 wt.% concrete. Also, the quench rate of the 8 wt.% concrete melts did not vary appreciably with pressure.