Experimental investigation of blade-shaped riblets for drag reduction on UAV applications

Abstract

This study presents an experimental investigation of blade-shaped riblets for drag reduction in unmanned aerial vehicle (UAV) applications. UAVs have gained significant attention since they can perform various missions, including surveillance, reconnaissance, and package delivery. However, their aerodynamic performance, specifically the high drag associated with their exposed surfaces, remains a key challenge for enhancing their efficiency and extending their flight endurance. To address this issue, riblet geometries are proposed as a potential solution, which can reduce the turbulent skin friction drag by up to 8%. The experimental investigation involves wind tunnel testing of blade-shaped riblets, with various spacing-to-height (s/h) ratios and constant groove cross-sectional area (Ag). The riblets are designed for application on the wing, empennage, and fuselage surfaces of a UAV. The investigations are performed on a flat plate for various flow conditions, including different freestream velocities, to evaluate the drag reduction effectiveness of the riblet configuration. The drag force is measured using a force balance system and flow visualization techniques are employed to assess the position where the boundary layer has transitioned to fully turbulent. The results demonstrate the drag-reducing effect of blade-shaped and trapezoidal riblets and the different performances observed for the various s/h ratios. The cases with s/h=1 result in the smallest drag coefficients, while the cases with s/h=2 have significantly increased drag values, compared to the smooth flat plate, due to the increased wetted surface area. These findings highlight the potential of riblets as an effective drag-reduction technique for UAV applications, enabling increased endurance and/or enhanced payload capacity.