Experimental investigation, intelligent modeling and multi-characteristics optimization of dry WEDM process of Al–SiC metal matrix composite

Abstract

Dry wire electrical discharge machining (WEDM) is an environmentally friendly modification of the oil WEDM process in which liquid dielectric is replaced by a gaseous medium. In the present work, parametric analysis has been fulfilled while dry WEDM of Al–SiC metal matrix composite. Experiments were designed and conducted based on L27 Taguchi's orthogonal array to study the effect of pulse on time, pulse off time, gap voltage, discharge current, wire tension and wire feed on cutting velocity (CV) and surface roughness (SR). Firstly, a series of exploratory experiments has been conducted to identify appropriate gas and wire material based on the values of cutting velocity. After selection of best gas and best wire, they were used for later stage of experiments. Analysis of variances (ANOVA) has been performed to identify significant factors. In order to correlate relationship between process inputs and responses, an adaptive neuro-fuzzy inference system (ANFIS) has been employed to predict the process characteristics based on experimental observation. At the end, an artificial bee colony (ABC) algorithm has been associated with ANFIS models to maximize CV and minimize SR, simultaneously. Then the optimal solutions that obtained through ANFIS-ABC technique have been compared with numbers of confirmatory experiments. Results indicated that oxygen gas and brass wire guarantee superior cutting velocity. Also, according to ANOVA, pulse on time and discharge current were found to have significant effect on CV and SR. In modeling of CV and SR by ANFIS, it was resulted that the proposed method has superiority in prediction of them in the ranges of factors beyond the training condition. Also, association of ANFIS with ABC can find the optimal combination of process parameters accurately according to the confirmatory experiments.