Abstract
The main objective of the research was to study the influence of the abrasive water jet cutting (AWJC) parameters on the surface roughness parameters Rz1max and Rt, obtained when processing Kevlar fiber-reinforced polymers (KFRP). For this purpose, a full factorial experimental program was designed and roughness evaluations were carried out in two different zones of the cut slot. In this way, it was possible to test the statistical significance of the input parameters effects and characterize both these regions, by means of prediction models proposed for each roughness parameter. Finally, response surfaces and level curves were represented to facilitate the selection of proper factors combination to achieve surface finish requirements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
