Abstract
Abstract: Optimization of machining processes is essential for achieving higher productivity and high-quality products in order to remain competitive. The objective of this study is to optimize the process parameter of extrusion blow molding process of high density polyethylene (HDPE). In this paper three process parameters namely barrel temperature, Mandrel Position, Screw Rotation. Taguchi Method is a statistical method to improve the process parameters and improve the quality of components that are manufactured. ANOVA has been carried out to identify importance of the operating parameters on the performance characteristics considered. Further the verification experiment has been carried out to confirm the performance of optimum parameters. The results from this study will be useful for selecting appropriate set of process parameters to epoxy coating has been selected. The analysis of variance (ANOVA) has been used to determine effect of each parameter on wear rate so Finally, the confirmation test has been carried out to compare the predicted value of wear rate with the experimental value.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal for Research in Applied Science and Engineering Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
