Abstract
Carbon free fuels such as hydrogen/ammonia blends show a promising potential to become sustainable and renewable fuels for gas turbines and other combustion systems. One interesting aspect about these blends is the possibility to adjust different combustion properties like the laminar burning velocity or ignition delay time by changing the ratio between H2 and NH3. Such fuel blends can be produced via partial catalytic decomposition of NH3. However, such mixtures can lead to flame instabilities such as flashback, especially if the hydrogen content is high. In the present study, the boundary layer flashback of premixed hydrogen/ammonia/air mixtures is investigated experimentally for non-swirling flows at normal temperature (293 K) and normal pressure (101 kPa). A new experimental setup for boundary layer flashback investigation with a fully automated measurement procedure is introduced. With preliminary studies, the influence of various measurement procedures on the flashback limits is firstly investigated. For a broad flashback study, the data of 351 flashback experiments are collected. The ammonia content in H2/NH3 fuel mixtures is varied from 0 vol% to 50 vol% in 10 vol% steps. The fuel–air equivalence ratio is ranging from 0.38 to 1.17. As the ammonia content is increasing, the mean flow velocities at flashback are exponentially decreasing. Additionally, theoretical modeling is performed. A model is derived based on the concept of the critical velocity gradient which is able to predict the measured data with high accuracy. For two exemplary cases with H2/air and 80% H2/20% NH3/air mixtures, the process of boundary layer flashback is investigated in detail with low and high speed direct imaging and image post-processing. During the flashback onset of H2/NH3/air flames a separate reaction of H2 followed by the reaction of NH3 can be observed. Also, a flame-oscillation between fused silica tube and burner head with approximately 10 Hz was observed. Furthermore, indications for an adverse pressure gradient based on the flame propagation speed is seen. Details about the flame structure during the flashback process of H2/NH3/air flames are shown. During the upstream flame propagation of H2/NH3/air flames, high frequency oscillations with about 830 Hz of the leading flame tip are observed, which are assumed to be related to thermoacoustic instabilities.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.