Abstract
High strength aluminum alloy members can be used if the required cross-sections are larger than those obtainable by extrusion. The application range of the current design codes for aluminum structures is limited for normal-strength material and whether high-strength members can be designed with the existed buckling curves is examined. Fourteen H-section columns made from 7075-T6 were tested under axial compression. The effects of the different material properties and imperfections on the flexural buckling behavior of normal- and high-strength columns were analyzed numerically. The column curves in European, Chinese and American specifications can predict flexural buckling resistance of such columns safely with an average underestimation of 13%, 12% and 8%, respectively. Eighty-one column buckling tests available in the literature performed on extruded sections made of aluminum alloy with the yield stress between 388 MPa and 557 MPa were collected and analyzed. Finally, a new flexural buckling curve was suggested for the estimation of flexural-buckling resistance of high-strength extruded members.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
