Experimental investigation and analysis of machinability behaviour of hybrid GFRP composites during end milling

Abstract

Purpose This paper aims to develop a mathematical model for analysing surface roughness during end milling by using response surface methodology (RSM) and to determine how the input parameters (cutting speed, depth of cut and feed rate) influence the output parameter (surface roughness) in the machining of hybrid glass fibre reinforced plastic (GFRP; Abaca and Glass) composite by using solid carbide end mill cutter. Design/methodology/approach Three factors and a three-level Box–Behnken design in RSM were used to carry out the experimental investigation. Handysurf E-35A was used to measure the surface roughness of the machined hybrid GFRP composites. The “Design Expert 8.0” was used to analyse the data collected graphically. Analysis of variance was carried out to validate the model and determine the most significant parameter. Findings The response surface model was used to predict the input factors influencing the surface roughness of the machined surfaces of hybrid GFRP composite at different cutting conditions with a chosen range of 95 per cent confidence intervals. Analysis of the influences of the entire individual input machining parameters on the surface roughness carried out using RSM. Originality/value The effect of the milling of hybrid GFRP composite on the surface roughness with solid carbide end mill by using RSM has not been analysed yet.