Abstract
An experimental investigation has been done on the changes of die angle, area reduction in dies, loading rate on the final extruded products, extrusion pressures of lead of circular cross sections of different length. The proposed method is successfully adapted to the extrusion of the equilateral triangular section from round billet through converging dies of different area reductions. Computation of extrusion pressure at various area reductions and finite element analysis of different parameters (stress, strain, velocity) both in dry and wet condition. Keywords - Converging dies, Extrusion of the equilateral triangular section, Extrusion Pressure
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
