Experimental evaluation of the ballistic resistance of aramid fabrics under near simultaneous multiple fragment impacts

Abstract

The ballistic resistance of protective equipment against fragment impacts, such as those typically generated from explosions, has been a major concern the past 50years. The simplifications required to investigate the material response to multiple fragment impacts were set based on the technological limitations of the past. Still, current standardised ballistic testing methodologies consider the interactions between multiple impacting fragments negligible, simulating the multiple impulsive loads with single impact tests. This paper challenges this assumption, introducing the parameters of spacing, formation and timing between multiple impacts in a laboratory test method.An in house pyrotechnical triple launcher is designed and implemented which can shoot three 1.102 g Fragment Simulating Projectiles (FSP) with each shot. An add-on dispersion unit allows for adjusting the distances between the impact points. The control over the projectile velocities and the dispersion of the three impact points enables the simulation of a dense fragment cluster impact with specific characteristics. The setup is used to test Aramid dry fabrics against fragmentation. In total 53 specimens of 15 layers of Kevlar 29 plain weave fabrics are tested against single and triple impacts with two different levels of projectile dispersion. The results show a drop in the target's ballistic limit of up to 13% against triple impacts compared to single impact tests. The fabric's ballistic performance seems to improve with increasing the distances between the impact points. For every triple impact test, the parameters: impacting velocity, distances between impact points, alignment of impact points with the warp and weft directions and time intervals between impacting projectiles is documented.