Abstract
An experimental apparatus to determine the heat-transfer coefficient in the gap formed between the cast metal and the mold wall of a vertical direct chill (DC) casting mold is described. The apparatus simulates the conditions existing within the confines of the DC casting mold and measures the heat flux within the gap. Measurements were made under steady-state conditions, simulating the steady-state regime of the DC casting process. A range of casting parameters that may affect the heat transfer was tested using this apparatus. In the current article, the operation of the apparatus is described along with the results for the effect of gas type within the mold, and the size of the metal-mold gap formed during casting. The results show that the gas type and the gap size significantly affect the heat transfer within a DC casting mold. The measured heat fluxes for all the conditions tested were expressed as a linear correlation between the heat-transfer coefficient and the metal-mold gap size, and the fluxes can be used to estimate the heat transfer between the metal and the mold at any gap size. These results are compared to values reported in the literature and recommendations are made for the future reporting of the metal/mold heat-transfer coefficient for DC casting. The results for the effect of the other parameters tested are described in Part II of the article.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
