Abstract
ABSTRACT The present work deals with the extraction and pre-concentration of nickel (II) ions using emulsified liquid membrane (ELM) in the presence of di- (2-ethylhexyl) phosphoric acid (D2EHPA) as an extractant. The emulsion stability was achieved by the biodegradable surfactants Triton X-100 addition diluted in kerosene. Influence of operating conditions that affect ELM performance were investigated. A comparative study between the optimization parameters of this process was carried out both experimentally and with the Response Surface Methodology (RSM), in accordance with the Box–Behnken matrix. The following parameters were investegated: D2EHPA / Triton X-100 ratio between 0.5 and 3.5, initial concentration of the feed phase between 200 and 500 ppm and pH of the feed phase from 2.5–10. The transport of Ni (II) ions was evaluated according to the extraction yield as an analytical response and the optimal conditions were determined. It was found that the calculated values being in good agreement with experimental data that under the optimized conditions ([Ni] = 350 ppm, Vagitation = 200 rpm, t = 20 min and pH = 6.6), Ni (II) ions extraction was recorded more than 94% of efficiency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.