Experimental Demonstration of Multigigabit Data Communication Using Surface Waves on Twisted-Pair Cables

Abstract

The demand for higher broadband speeds is ever increasing whereas the deployment of full fibre to the premises is slower than initially predicted and remains costly. Solutions exploiting the existing, ubiquitous, copper network and increasing its capacity would be highly beneficial in the near term. One approach is to use surface wave (SW) transmission mode to transmit signals over the existing copper cabling network. We present proof-of-concept experimental SW data transmission on twisted pair cables. A surface wave launcher for low GHz carrier frequency operation is designed and optimised. Experimentally, we demonstrate data rates in excess of 12 Gb/s in a 1.15-3.25 GHz band over a 6.1 m twisted pair cable with an average bit error rate of <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$2.25 \times 10 ^{-5}$ </tex-math></inline-formula> , without coding or feedback implementation. Furthermore, higher frequency bands are tested with data rates up to 3.4 Gb/s displaying their potential for surface wave transmission. S-parameter measurements allow capacity estimations of SW data transmission on longer cable lengths using water-filling algorithms. Our calculations predict over 13 Gb/s capacity on a 100 m cable using a 3.5 GHz transmission bandwidth, this may be further extended by further increases to the bandwidth used for SW transmission.