Abstract
New saturated critical heat flux (CHF) experiments for refrigerants flowing into a multi-microchannel heat sink are presented in this paper. These tests integrate an existing database (Mastrullo et al., 2016) by adding new fluids and operating conditions. The test section consists of an aluminum heat sink heated from the bottom and made up of seven rectangular microchannels, each of them 35mm long and 2mm wide. The possible heights are 1.0 and 0.5mm, whereas the heated lengths are 25 and 35mm, thus obtaining three different Lh/D ratio of 19, 27 and 44, respectively. R134a and the low-GWP refrigerants R1234ze, R1234yf and R32 are used as working fluids. The mass flux was varied from 146 to 1504kg/(m2s) and tests were performed at saturation temperatures from 24.7 to 75.5°C. With a new operative definition of critical heat flux, the experimental results show that CHF is strongly enhanced with higher mass fluxes, while it is only slightly influenced by the saturation temperature. The effect of Lh/D is a CHF reduction at low mass velocities (G<500kg/(m2s)), while the trend is reversed for high mass velocities. Finally, the agreement of the present database with some of the most quoted CHF correlations is also tested. The comparison results show that the correlation of Callizo (2010) best fits the whole database and also the low-G data, whereas the predictive methods of Ong and Thome (2011) and Wojtan et al. (2006) work better at higher mass fluxes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
