Abstract
A special prefabricated fiber reinforced polymer (FRP) composite shield or jacket was developed to repair wood piles in the field. Two types of load-transfer mechanisms between the wood pile and the FRP composite shield were developed and tested: (1) cement-based structural grout; and (2) steel shear connectors with an expanding polyurethane chemical grout. The objective of this paper is to characterize the structural response of full-size pre-damaged wood piles repaired with the FRP composite shield system. A three-point bending test procedure was used to simulate the response of a pile subjected to lateral loads. The load-deformation response, deflected shape profile, relative longitudinal displacements (slip), strain distribution, ultimate bending moment capacity and mode of failure were evaluated. Wood piles were pre-damaged by reducing approximately 60% of the cross-section over a portion of the pile. It was found that a pre-damaged wood pile repaired using the FRP composite shield with cement-based grout exceeded the bending capacity of a reference wood pile. The repair system using the FRP composite shield with steel shear connectors and polyurethane grout did not fully restore the bending capacity of a reference wood pile; however it can be used for marine borer protection when wood damage is not critical.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
