Abstract
Abstract The extrusion of EPDM compounds with a two-stage vented screw has been studied. Experimentally, the pressures and temperatures were measured at the end of each stage, for different processing conditions (screw speed, die geometry etc.). Screw pulling experiments have allowed to observe the partially filling of the different screw sections. Assuming a power-law pseudoplastic behaviour for the rubber compound, the flow in each stage of the screw has been computed. The evolutions of the pressure and the temperature all along the screw, as well as the filling length of the second stage are then obtained. The theoretical results are in good agreement with the experimental measurements.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
