Experimental and simulation studies to optimize the mechanical alloying process of ODS-FeCrAl alloy powder

Abstract

Oxide dispersion strengthened (ODS) FeCrAl alloy exhibits superior mechanical qualities at high temperatures and resistance to neutron irradiation, making it a highly promising material for accident-tolerant fuel cladding. The preparation of ODS-FeCrAl alloy powder by mechanical alloying can mix Y2O3 and FeCrAl alloy powder uniformly and promote the uniform dispersion of nanoscale oxide particles in the alloy matrix. The preparation of ODS-FeCrAl alloy powder by the mechanical alloying method is greatly influenced by the rotational speed. Therefore, this study uses a combination of experiments and numerical simulation to investigate the effects of different rotational speeds on the microscopic morphology, particle size and force of alloy powder during the ball milling process. The mechanically alloyed powder was subjected to XRD inspection to determine the optimum ball milling time at each rotational speed by means of the maximum lattice distortion, and then the powder micromorphology and particle size were analyzed. Then the forces on the powder and grinding ball during the ball milling process were analyzed by numerical simulation, and it was found that the collision force and normal force played a dominant role in the ball milling process. The combined experimental and simulation results determined that the ODS-FeCrAl alloy powder obtained by ball milling at 300 rpm for 35 h had the largest lattice distortion, fine grain size and uniform particle size, which achieved the best mechanical alloying effect.