Abstract

An experimental investigation has been carried out to study the effect of unsteady periodically impinging jets on the flow field and heat transfer characteristics. The experiments are performed for steady jets and for typical periodical jets (i.e., sinusoidal and rectangular jets) at frequencies from 1.25 to 40Hz. The periodical jets are produced by a special mass flow rate controller. The investigation shows that the stagnation point heat transfer does not show any enhancement for the periodically impinging jets when the frequency is lower. Various signals of unsteady jets show distinguishing frequency dependences and the rectangular jet, which has a step change in signal function itself, is the most effective one for heat transfer improvement and the degree of enhancement is in the range 30–40% at frequency of 40 Hz. This increase is believed to be caused by higher oscillations and strong entrainments to the ambient fluid. The hotwire anemometry is used to measure the velocity at centerline of the nozzle and PIV is used to measure the phase-locked flow field of the periodically impinging jet. The flow field is also obtained by numerical simulation with CFD.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.