Experimental and numerical study on flow characteristics and heat transfer of an oscillating jet in a channel

Abstract

A fluidic oscillator can produce self-induced and self-sustaining oscillating jet by fluid supply without moving parts. This device has attracted research interest in heat and mass transfer enhancement in recent years. In the current study, a double-feedback fluidic oscillator was numerically investigated based on three-dimensional unsteady Reynolds-averaged Navier-Stokes equations (3D-URANS) while the operating fluid is an incompressible flow. Then, the results were validated with experimental data by two-dimensional time-resolved particle image velocimetry (2D-TR-PIV) and thermographic phosphor thermometry (TPT) for the velocity and temperature field, respectively. A grid sensitivity study was done by comparison of instantaneous and time-averaged flow fields. Additionally, the proper orthogonal decomposition (POD) method was used to find the phase information of the oscillating jet, and fast Fourier transform (FFT) analysis was used to find the frequency of the oscillating jet to validate the numerical results. The effect of the working fluid was also studied. Finally, in order to determine the effect of the Reynolds number on heat transfer enhancement, the Q-criterion was calculated to provide detailed insight into the oscillating mechanism. The results show that the non-dimensional frequency of oscillation is independent of either the working fluid or mass flow rate. Additionally, for a given fluid, increasing Re causes strong vortices and increases the frequency of oscillation. However, the convection heat transfer did not change significantly when varying the mass flow rate because the convection velocity of vortices increases as the mass flow rate is enhanced. A comparison with a free jet reveals that the oscillating jet in a channel is useful in terms of covering a larger area.