Experimental and numerical study on ferrohydrodynamic and magneto-convection of Fe3O4/water ferrofluid in a sudden expansion tube with dimpled fins

Abstract

BackgroundThis study experimentally and numerically addresses magnetohydrodynamic forced convection including dimpled fins, Fe3O4/water ferrofluid, and DC magnetic field. In this research, focusing on the thermo-hydraulic performance improvement of a sudden expansion tube. It has been used different inlet diameters, dimple sizes, ferro nanoparticle concentrations, and magnetic field strengths to examine the heat transfer and fluid dynamics characteristics of the system. MethodsThe study consists of two parts, i) experimental and ii) numerical. Steady-state, incompressible, Newtonian flow were considered but chemical reaction, viscous dissipation, buoyancy, and radiative heat transfer were neglected in this study. On the other hand, numerical solutions were carried out for single-phase method. This study was first compared with the studies in the literature on the flow in a sudden expansion tube without dimpled fins and the error rate was found to be less than 10 %. In the analysis, dimpled fins with d=3, 5, and 7 mm at each P=15 mm (P/d=5.0, 3.0, and 2.14) have been used. As working fluid, Fe3O4/water ferrofluid with volume concentration of φ=1.0 % and 2.0 % have been analyzed. Additionally, DC magnetic fields, which strength of Ha=0.1, 0.3, 0.5, 1.1, 3.2, and 5.3 (B =0.01, 0.03, 0.05, 0.1, 0.3, and 0.5T), have been applied on the sudden expansion tube surface as external force. Significant findingsDimpled fins enhance the heat transfer by disrupting the boundary layer and forming secondary flows, while the ferrofluid increases the thermal conductivity and viscosity of the base fluid. Based on these explanations, dimpled fins increased the convective heat transfer rate at the rate of 96.0 % compared with smooth tube. In addition, Fe3O4/water ferrofluid with φ=2.0 % performed the highest performance and performance evaluation criteria increased by 8.5 %. The magnetic field also contributes to the heat transfer enhancement by inducing Lorentz force and mixing the flow. Excessive increasing of magnetic field strength adversely affected the system performance, and the highest performance evaluation criterion is acquired at Ha=3.2 by increasing 3.9 %. Compared with smooth tube, compound effect of dimpled fins, Fe3O4/water ferrofluid, and magnetic field improved the average Nusselt number and performance evaluation criterion at the rate of 279.8 % and 207.9 %, respectively.