Experimental and Numerical Studies of the Effect of Microstructure of Ionic Conductors on Generation of Hydrogen in Solid Oxide Electrochemical Cells (SOC)

Abstract

Ceramic ionic conductors are applied in innovative systems for highly efficient and clean power generation. The oxygen separation membranes and solid oxide fuel cells (SOFC) and solid oxide electrolyzers (SOE) can be the examples.Influence of various structural properties of ceramic ionic conductors which are used for solid oxide fuel cells was well-defined and described using several mathematical models. Such parameters as ionic and electronic conductivity, porosity, tortuosity, shape and distribution of pores were included. In case of solid oxide electrolysis cells, effects of these parameters on the electrolysis reaction remain unclear and obscure. There is no clearly defined correlation, neither there is an optimization tool for modification of the parameters to maximize the performance of solid oxide cell operating in regenerative mode. For that reason it is necessary to perform a complete comprehensive analysis combining both the experimental and numerical techniques to identify the key microstructural parameters and their correlation with the performance of electrochemical reaction. The work was aimed at verification of data presented in earlier studies which advised that porosity of electrodes of SOEs needs to be different than in the case of SOFCs, however different values were claimed. Mingyi et al. [1] indicated that optimum porosity for SOEC is about 45%, however several other studies advised on different values.This paper presents results of numerical simulations and correlation of material properties with operational characteristic of a solid oxide electrochemical cell which were followed by initial experimental investigations towards validation of the numerical model, including the analysis of selected operational states. Model was established on the basis of theoretical correlations between microstructural parameters and macro-level performance. It was used for performing variant analysis of different modes of operation under varied conditions. The outcomes of the numerical investigations made it possible to define the requirements for fabrication of modified cells for high temperature electrolysis which were studied.The work presents preliminary results of electrochemical characterization of modified cells and an attempt to generalize the model of SOC customized to highly efficient electrolysis.The general concept of optimizing the performance of SOE by fine-tuning of the microstructure which was proposed earlier [2] is assessed throughout experiments using in-house 50 mm x 50 mm cells fabricated in the Institute of Power Engineering. The proposed path for tailoring the microstructural properties is presented and discussed.