Experimental and Numerical Investigations on Strains of Metal Sheet Parts Processed by Electromagnetic Forming

Abstract

Electromagnetic forming is applied to form metal sheet parts from both non-ferrous and ferrous materials. In this paper, the electromagnetic forming behavior of aluminum alloy, copper and steel sheets was investigated through experiments. The disk-shaped specimens were electromagnetically free bulged with increasing deformation energies and parts with different deformation depths were obtained. The deformation was done with and without clamping the movement of the specimens’ edges. The specimens were printed with a mesh of diametrical lines and concentric circles with a predetermined pitch. The mesh served to determine the displacements in the mesh nodes after the deformation of the specimens, with which the axial, radial and circumferential strains were then calculated. The experimental data obtained was subjected to statistical correlation and regression analyses, and the mathematical models for the three main strains in each material were established. The strains of AlMn0.5Mg0.5 and Cu-OF parts are maximum in the center and have a similar variation, while the FeP04 parts have the maximum strains in an intermediate zone between the center and the edge.