Experimental and numerical investigations of the plastic response and fracturing of an aluminium-plated structure with transition circular arcs subjected to impact loading

Abstract

A new aluminium-plated structure with transition circular arcs used for railway vehicles is presented. Two impact experiments were performed using a test trolley to examine the plastic response and fracturing of the aluminium-plated structure. The results show that the deformation mode of the aluminium-plated structure switches from global plastic bending deformation to local fracturing at the transition circular arc region, which is consistent with the design. Numerical results are presented in terms of deformation modes, force responses and levels of absorbed energy, demonstrating good agreement with the experimental results. From the results of the numerical simulation, fracturing processes and variations in element stress triaxiality are presented. It is found that the stress state of elements affecting the initiation of cracking is of a tension state, while the stress state of elements affecting the end of cracking is of a shear state. A validated finite element analysis of an aluminium-plated structure with right-angled, circular arcs and chamfering transition sections is presented. Plastic and fracture energy levels of the aluminium-plated structure with three transition sections are measured as 2.56, 27.62, and 30.13 kJ and 0.98, 2.41, and 2.16 kJ, respectively, as the second fracturing point. Finally, the finite element analysis illustrates the impact energy effects involving different combinations of trolley mass and velocity, and experimental boundary conditions for varying bolt yield stress and pre-stress levels are defined in the finite element model to investigate the effects of bolted joints on the dynamic responses of an aluminium-plated structure with transition circular arcs.