Abstract
Abstract The effect of pre-stress on the buckling behaviour of geometric unit cells of collinear square lattices is investigated experimentally and numerically. The geometric unit cells are manufactured using fused deposition modelling. Manufacturing strategies are presented which incorporate fibres subjected to pre-stress within the unit cell. The effect of pre-stressed fibres is analysed by comparing the compressive behaviour of unit cells with and without fibre reinforcement. The buckling behaviour of the unit cells is also investigated numerically by employing a parametric study within Abaqus varying the pre-stress in the fibres. The experimental test series shows that the addition of pre-stressed fibres to the system results in an increase in buckling and maximum load of 260%–480% and 220%–350% respectively. The increase strongly relates to the manufacturing quality, i.e. the bonding between the lattice material and the fibres, where a sufficient bonding yields significantly larger loads. The experimental findings on the qualitative and quantitative buckling behaviour correspond well with results obtain from the numerical study.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
