Experimental and numerical investigation on performance of a swirling jet reactor

Abstract

In this work, a three-dimensional Computational Fluid Dynamic (CFD) analysis of a swirling jet reactor was implemented to gain a better understanding of fluid dynamics into the reactor. The effect of different geometries of the reactor, by considering different diameters of the injection slots of the reactor, on flow velocity and flow pressure distributions was investigated. Firstly, a one-phase model was implemented by considering only water into the reactor. Then, a two-phase model was defined including dissolved air into the water. The inlet flow pressure was set to 0.25 bar to consider non-cavitating conditions and, then, to get more accurate results on fluid dynamics into the reactor due to the absence of cavitating conditions. Data collected from experimental tests were used to calibrate and validate the model. Results of numerical simulations were in good agreement with experimental data, showing for all the geometries a rotating flow around the central axis of the reactor and at the exit of the double cone. The highest flow velocities and flow pressure drops were observed for the reactor geometry with the smallest injection slots diameters. Finally, noise measurements were performed during another set of experimental tests by considering different inlet flow pressures.