Abstract
A water evaporator is a phase change heat exchanger, as a heat sink, especially for high-speed flight vehicles. It is composed of internal channels for convective cooling and external fins for boiling. In this paper, six water evaporators, Hex0–Hex5, are designed with five different internal channels and two different external fins. The VOF simulation models are built to investigate their boiling heat transfer performances in a sub-atmospheric environment. Experimental studies were carried out to verify the accuracy of the numerical model of water evaporator. The simulation results show that the structures of the internal channel and external fin both have an impact on the heat transfer performance. For the internal channels, their height change has much more obvious effect than their structural continuity. For the external fins, the increase of the fin bulge structure helps to improve the heat transfer performance. For the aircraft, the optimal design structure of water evaporator is Hex4 and its heat transfer performance can be improved by 13.31% compared with Hex0.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.