Experimental and Numerical Investigation of Static and Dynamic Characteristics of Bio-Oils and SAE40 in Fluid Film Journal Bearing.

Abstract

Mineral-based oils are the market leaders when it comes to their consumption in different types of rotating machines. Recently, a lot of attention has been given to the bio-oils and lubricants due to their better thermophysical, tribological, and environmental characteristics for use in journal bearing and other rotating machines. The superior physical properties of bio-oils have instigated this research in order to evaluate their dynamic characteristics that can cause the harmful dynamic instabilities in rotating machinery. The dynamic characteristics of the fluid film are influenced by temperature, eccentricity ratio, and rotational speed. In this work, the effect of temperature is experimentally measured on the dynamic viscosity of bio-oils and mineral-based oil. The dynamic viscosity measured is then computationally used to estimate the hydrodynamic pressure response of three bio-oils (rapeseed, palm olein, and soybean) and SAE40, a mineral-based oil, to check their performance in the rotor bearing system. It is found that at 40 °C, the hydrodynamic pressure for SAE40 is observed to be 2.53, 2.72, and 3.32 times greater than those of rapeseed, palm olein, and soybean oil, respectively, whereas, at 125 °C, the hydrodynamic pressure for SAE40 is observed to be 8% and 4.3% less than those of rapeseed and palm olein, respectively, but 14% greater than that of soybean oil. Hence, the increasing temperature has less effect on the viscosity and hydrodynamic pressure of bio-oils compared to SAE40. Therefore, for high-temperature applications, the bio-oils can be used with further processing. The superior response of bio-oils is also an indication for better dynamic characteristics.