Experimental and Numerical Investigation of Intact, Defective and Repaired Countersunk Composite Joints under Tensile Loading.

Abstract

Bolted joints are commonly used for assembling carbon fiber/resin composite structures. Since drilling may generate defects at hole edges which affect mechanical properties, it is of great engineering significance to develop proper repair methods to restore the mechanical properties of the defective parts. However, there are few studies on hole edge defects and their repair methods. Therefore, a novelty short fiber filling repair method was proposed to repair defective holes in this study. The mechanical properties of intact, defective and repaired countersunk composite joints were compared and investigated. Experimental tensile tests showed that defective joints had lower initial stiffness and failure loads compared to intact joints, while the mechanical properties were effectively restored after repair. Three-dimensional finite element models were also established to analyze the damage process of the joints. Results of numerical modelling were consistent with the experimental results. The simulations showed that changes in contact behaviors and local deformations caused by hole edge defects led to the low initial stiffness and stiffness transition point of the joint, while this phenomenon was reduced after repair. Additionally, despite different joint types, laminate failure mainly occurred around the hole and countersink.