Abstract
Abstract A frequent problem in the production of metallocene linear low-density polyethylene (mLLDPE) films is the occur-rence of flow instabilities, e.g. sharkskin, or degradation of material, which limit the production rate and decrease the product quality. If such problems arise, the question is what causes these phenomena and how they can be avoided. With the aim of understanding these problems and providing some guidelines for their suppression, rheological measurements together with modelling of these melt flows are often employed. In the present study, flow behaviour of two commercially available mLLDPEs was determined and used for the process simulation. The paper shows that the capillary-rheology data together with 2D finite element method can be used for the prediction of sharkskin phenomenon as well as degradation of mLLDPE melts in film blowing dies. It also reveals that the degradation of the materials in these dies can be quantified through wall shear stress. Finally, the paper describes how these findings can help optimize the flow channel in the film blowing die to avoid the undesirable flow phenomena.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
