Experimental and numerical flexural buckling resistance of high strength steel columns and beam-columns

Abstract

The use of high strength steel (HSS) has been consolidated around the world because of its numerous advantages mostly for high-rise buildings and large span bridges. As it provides the possibility of a design with slender sections, substantial reduction in the structure weight is expected, but special attention should be given to the stability of the HSS compression members. However, the existing design codes for HSS columns are limited and based on experimental data related to normal strength steel (NSS) materials, which is responsible for an inaccurate resistance prediction. In this sense, the present paper aimed to investigate the buckling behavior of S690 HSS welded I-section columns failing by flexural buckling around the both principal axes and beam-columns failing by lateral torsional buckling. The experimental campaign contemplated 4 pin-ended columns, in which 2 were tested about their major-axis and the other 2 about the minor-axis, and also 2 beam-columns, including supplementary experimental to measure the geometric imperfections, residual stresses and material properties of the S690 welded I-section columns and beam-columns. In the following, a numerical model was built and validated against the experimental results and afterwards employed to perform a sensitivity study considering different membrane residual stress patterns. Finally, the European [1,2], American [3], and Australian [4] codes were assessed by comparing the design resistances with the results from the experimental tests and the collected test data of relevant studies, showing in general a considerable level of conservatism.