Abstract
This paper focuses on the influence of the step drill bit geometry on the damage induced during drilling Carbon Fiber Reinforced Polymer materials (CFRPs). Step geometry designed with the aim of avoiding composite damage in CFRPs drilling, is compared to conventional twist configuration. Despite the reduction of thrust force and torque observed when using the step drill, the delamination was only reduced at low feed rates. A numerical model developed for the step geometry was validated with experimental data demonstrating its ability to predict thrust force and delamination for different values of feed rate and cutting speed. Numerical model allowed the development of a parametrical study. Finally, using a response surface methodology a mechanistic model and surface diagrams have been presented in order to help in the selection of optimum variables minimizing drilling induced damage.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
