Experimental and computational study on thermo‐mechanical fatigue life of aluminium alloy piston

Abstract

AbstractTo assess the life of a new diesel aluminium alloy piston under thermal shock loads, thermo‐mechanical fatigue (TMF) testing was conducted to characterise the TMF properties of the piston alloy, and an empirical model based on the constraint ratio concept was proposed to predict the TMF life of the piston. Considering that the empirical model required expensive experimental support, a platform with high‐frequency induction heating was established to simulate the force on the piston under thermal shock loads to calculate the piston life using the thermal shock test. Additionally, a finite element method was developed to compute the distributions of temperature, strain, and stress during this process. The characteristics of crack initiation and propagation in TMF test rods and piston mock‐ups were also investigated. The results showed that the TMF test rod suffered brittle fracture with brittle quasi‐cleavage features. The microcracks mainly occurred in primary Si particles due to stress concentration around the primary Si particles induced by the difference between the thermal expansion coefficients of Si and Al. From a macro perspective, the piston initially cracked at the rim above the pinhole, where the stress is larger than that along other directions. From a micro perspective, the protrusions of various sizes on the piston rim were induced by the compression stresses at high temperature. The piston cracks usually initiate around primary Si particles, propagate along the edge of primary Si in a straight line, bifurcate and then stop at a certain depth. If the piston was only heated, cracks or plastic deformations were not produced. The piston life can be assessed using the proposed empirical model based on the constraint ratio concept or thermal shock testing based on the developed platform. The difference between the predicted and experimental life was not greater than 7%.