Abstract
Auto-ignition of finite thick PMMA (polymethyl methacrylate) subjected to linear time-increasing heat flux (HF) is experimentally investigated utilizing a heating apparatus capable of freely controlling the variation of the exposure. Ignition times, surface and in-depth temperatures of samples were recorded. Theoretical analysis, using critical temperature, and numerical simulations considering pyrolysis and thermal insulation layer were implemented to estimate the corresponding measurements. Approximate correlations are obtained based on the analysis and they are related to the ones in thermally thick cases. Results show that the thermal insulation layer and the pyrolysis in solid have limited and significant effects on surface temperature, respectively. 1 mm PMMA cannot be treated as thermally thin due to the large temperature gradient in solid. Appreciable sample distortion and thickness regression observed in thin sample tests are responsible for the large uncertainty of ignition time and non-ignition phenomenon. Thinner sample and larger increasing rate of HF would lead to higher surface temperature and shorter ignition time. Two stages separated by pyrolysis temperature are identified before ignition. The measured critical temperature is 695 ± 14.5 K, and a more reasonable uncertainty range, ±30 K, is suggested by numerically fitting the measured ignition times.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.