Abstract
Micro electrical discharge machining (micro-EDM) has some shortcomings such as poor material removal rate (MRR) and high electrode wear ratio (EWR) etc, in order to overcome these demerits, a new piezoelectric self-adaptive micro-EDM, based on inverse piezoelectric effect, was developed in this paper. The structure and working principle of this new technology are different from traditional micro-EDM. Piezoelectric actuator used as the micro driven mechanism and it is simple. This new technology can realize self-elimination in the working process because of its special structure. Working principles and process of the new system were analyzed in this paper. The effect of parameters such as voltage, capacitance, and resistance on MRR, EWR and surface roughness was analyzed. Statistical analyses of the results show that voltage, capacitance significantly influence MRR, EWR and surface roughness. Resistance R1 and R2 has much influence on MRR and relative small effect on EWR and surface roughness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
