Experimental analysis of heat and mass transfer in non-isothermal sloshing using a model-based inverse method

Abstract

Nonisothermal liquid sloshing in partially filled reservoirs can significantly enhance heat and mass transfer between liquid and ullage gasses. This can result in large temperature and pressure fluctuations, producing thrust oscillations in spacecraft and challenging thermal management control systems. This work presents an experimental characterization of the thermodynamic evolution of a cylindrical reservoir undergoing sloshing-induced thermal de-stratification. We use a 0D model-based inverse method to retrieve the heat and mass transfer coefficients in planar and swirl sloshing conditions from the temperature and pressure measurements in the liquid and the ullage gas. The experiments were carried out in the SHAKESPEARE shaking table of the von Karman Institute in a cuboid quartz cell with a cylindrical cut-out of 80 mm diameter in the center, filled up to 60 mm with the cryogenic replacement fluid HFE-7200. A thermal stratification with ΔT=25 K difference between the ullage gas and liquid was set as the initial conditions. A pressure drop of 90% in the ullage gas was documented in swirling conditions. Despite its simplicity, the model could predict the system’s thermodynamic evolution once the proper transfer coefficients were derived.