Experimental analysis of drop size distribution and nucleation site density during dropwise condensation from humid air flow

Abstract

Condensation of the water vapor present in the air is a heat and mass transfer process encountered in many applications as humid air dehumidification and water harvesting. Depending on the wettability characteristics of the surface, condensation can take place in filmwise mode or in dropwise mode with the formation of discrete liquid droplets over the condensing surface. While dropwise condensation (DWC) of pure steam was found to promote a considerable enhancement of the heat transfer compared to filmwise condensation, when dealing with humid air DWC more investigation is needed. Modeling of DWC from humid air requires the calculation of the heat flow rate through a single droplet and the determination of the drop-size distribution. The heat exchanged through a single droplet depends on the heat and mass transfer resistances, while the drop-size distribution is also affected by nucleation site density and droplets mobility. Therefore, to better understand the DWC phenomenon with humid air and for the validation of the models, it is necessary to measure the heat flux (total and latent), droplet population and nucleation site density. In the present work, condensation tests from humid air are performed over two square (40 mm x 40 mm) aluminum samples that display different wettability. The experimental apparatus consists of a closed air loop with two main components: the environmental chamber and the test chamber. The air is conditioned in the environmental chamber and then it flows inside the test section where the vapor present in the humid air is condensed over the vertical metallic sample. Two variable speed fans are used to circulate the air. The test section is designed for heat and mass transfer measurements and for simultaneous visualization of the condensation process. As a peculiar characteristic of the present experimental technique, all the test section assembly is suspended on a high precision balance allowing a precise measurement of the mass of condensate. The effect of surface wettability on the heat and mass transfer during DWC is investigated. Time-lapse videos of the condensation process are acquired at different magnifications. By using a homemade MATLAB® program for droplet detection, recorded images are analysed allowing the determination of both the drop size density distribution (small and large droplet population) and the nucleation sites density.