Abstract
The good atomization performance of the pressure swirl nozzle makes it widely used in the fuel injection device of the internal combustion engine. Flash spray caused by fuel inlet superheat can affect spray and combustion characteristics. In this paper, a spray parameter measurement system is set up, combined with phase Doppler particle analysis (PDPA) technology to research the effect of superheat on spray velocity and droplet diameter distribution. To improve the safety of the experiment, Methyl Nonafluorobutyl Ether (HFE7100) with a boiling point of 61°C was used as the spray fluid. The cavitation model and VOF model are used to simulate the pressure swirl nozzle flash spray. The results show that when the temperature changes from 40°C to 60°C, the velocity of spray droplets increases and the particle size decreases under the action of weak evaporation; When the temperature changes from 60°C to 70°C, the evaporation mode is dominated by flash, making the droplet velocity at the spray center greatly increase and the velocity distribution change from saddle-shaped distribution to unimodal distribution. The droplet diameter increases, which may be due to the expansion of the droplet caused by the formation of bubbles inside the droplet under the action of flash.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
