Abstract
Centrifugal impellers C1,C2 and C3 are designed by using of three-order blade profile with the same basic geometry, such as radius,blade width and angle in the inlet and outlet,the number of the blades,and the designed rotating speed is also the same.The wrap angle of C1,C2 and C3 is 59°,75°and 91°respectively.The profile of impeller C1 is very close to the ones of traditional single-arc.The test results indicate that the best efficiency of C2 is 1.28%,1.43% higher than C1 and C3 re- spectively.By numerical simulation at the designed flow rate, the distribution of the relative velocity and load in the impeller is obtained.In the impeller C1 there is recirculation flow and load distribution in different passage is different.The study indicates that there is a best wrap angle and the single-arc is not the best blade profile.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.