Abstract
Integrated Ocean Drilling Program Expedition 308 quantified the coupling between sedimentation, consolidation, overpressure, fluid flow, and slope instability in continental margin settings. We summarize and synthesize peer-reviewed hydrogeologic studies published since the end of Expedition 308 that focus on Expedition 308 sites drilled in Ursa Basin: Sites U1322, U1323, and U1324. There is a rich stratigraphic complexity in the Ursa Basin, deepwater Gulf of Mexico. The sandstone-prone Blue Unit is a permeable aquifer overlain by mudstone-prone leveed-channel deposition. Multiple mass transport deposits, each densified relative to surrounding material, are present. Eight coeval surfaces mapped across the drilling transect span ~70 ka to present. Sedimentation rates were >10 mm/y at Site U1324. In situ penetrometer measurements document severe overpressures that begin at or near the seafloor and extend to the base of the drilled holes. Uniaxial consolidation experiments quantified the compression behavior of the sediments and provided an approach to predict pressure from porosity. Laboratory analysis of permeability and compressibility document that the coefficient of consolidation (hydraulic diffusivity) of Ursa Basin mudstones is 10–8 m2/s over the effective stresses encountered during drilling at Ursa Basin (0.1 to 5 MPa). This low and constant value for the coefficient of consolidation is responsible for the presence of high overpressure very near the seafloor. Although permeability is very high, the sediments are also highly compressible. Forward modeling of Ursa Basin sediments shows that overpressure near the seafloor is reasonable given the rock properties and sedimentation rates that are observed. Modeling also illustrates that flow is driven laterally along an underlying aquifer, the Blue Unit. Soon after Blue Unit deposition, lateral flow induced submarine landslides. Later in the evolution of this system, overpressure may have preconditioned the slope to failure by earthquakes of magnitude 5.0.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.