Abstract

City buses are one of the main means of public transport in cities. As they move in a limited and densely populated area and are intensively exploited, it is particularly important that they are environmentally friendly. There are many ways to reduce emissions from city buses, including the use of hybrid propulsion. Another way is to use low-emission fuels. This article presents the results of the emission tests of an 18 m articulated city bus with a serial hybrid drive fuelled comparatively by conventional diesel fuel and oxygenated fuel containing 10% v/v of triethylene glycol dimethyl ether (TEGDME). The emission tests were carried out during the actual operation of the bus on a route in Poznań (Poland) and over the SORT cycles. The obtained test results were compared also with the results obtained for a conventional bus. The reduction in emissions of some exhaust components was found when the hybrid bus was fuelled with oxygenated fuel during its actual operation on the bus route. There was a reduction in CO emissions by ~50% and NOx emissions by ~10%. Almost identical levels of PM and HC emissions and smoke opacity were observed for both fuels. In the SORT cycles, the differences in the emissions obtained for both types of fuel were small. In general, for the hybrid bus, a lower influence of oxygenated fuel on emissions was recorded than for the conventional bus.

Highlights

  • IntroductionThere is the highest density of moving vehicles, and a huge number of emission sources

  • The areas with the worst air quality include large urban agglomerations [1,2,3]

  • The Solaris Urbino 18 Hybrid bus used in the research was equipped with a serial hybrid drive system

Read more

Summary

Introduction

There is the highest density of moving vehicles, and a huge number of emission sources. Vehicle traffic conditions in large cities are usually unfavourable (low average speed, frequent braking, stopping and accelerating) and favour high fuel consumption and high exhaust emissions. Thanks to the use of advanced injection systems and effective exhaust aftertreatment systems [9,10,11,12]. This is perfectly illustrated by the lower and lower levels of exhaust emissions permitted by law [13,14]. The introduction of reformulated diesel fuels, containing less than 10 ppm of sulphur, played an important role

Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call