Abstract

The transition towards higher shares of electricity generation from renewable energy sources is shown to be significantly slower in developing countries with low-cost fossil fuel resources. Integrating conventional power plants with concentrated solar power may facilitate the transition towards a more sustainable power production. In this paper, a novel natural gas-fired integrated solar combined-cycle power plant was proposed, evaluated, and optimized with exergy-based methods. The proposed system utilizes the advantages of combined-cycle power plants, direct steam generation, and linear Fresnel collectors to provide 475 MW baseload power in Aswan, Egypt. The proposed system is found to reach exergetic efficiencies of 50.7% and 58.1% for day and night operations, respectively. In economic analysis, a weighted average levelized cost of electricity of 40.0 $/MWh based on the number of day and night operation hours is identified. In exergoeconomic analysis, the costs of thermodynamic inefficiencies were identified and compared to the component cost rates. Different measures for component cost reduction and performance enhancement were identified and applied. Using iterative exergoeconomic optimization, the levelized cost of electricity is reduced to a weighted average of 39.2 $/MWh and a specific investment cost of 1088 $/kW. Finally, the proposed system is found to be competitive with existing integrated solar combined-cycle plants, while allowing a significantly higher solar share of 17% of the installed capacity.

Highlights

  • It is a fact that the global energy sector is in a transitional phase towards a higher share of renewable energy supply

  • The analysis showed that integrated solar combined-cycle (ISCC) has more economic advantages in harnessing solar energy than standalone concentrated solar power (CSP) with or without thermal energy storage

  • The exergy analysis results showed that the proposed ISCC base case reaches an exergetic efficiency of 50.7% during daytime, which increases during night operation to 58.1%

Read more

Summary

Introduction

It is a fact that the global energy sector is in a transitional phase towards a higher share of renewable energy supply. In particular in the Middle East and North Africa (MENA) region, have decent potential for deploying concentrated solar power (CSP) with a direct normal irradiance (DNI) of up to 2500 kWh/m2 a, but face many challenges in introducing such systems owing to their high capital investment cost, technological advancement, as well as lack of supporting regulations and financial incentives. Solar energy technologies without storage cannot compete with conventional baseload plants owing to their intermittent nature. The operation policy of the existing thermal power plants is based on considering natural gas as the primary fuel owing to its evident economic and environmental advantages, representing more than 80% of the installed capacity in the past years [1]. Thermal energy conversion enables CSP plants the great advantage to offer dispatching power and increase the system capacity factor when integrated with either thermal energy storage or conventional fuels [2,3]. To provide reasonable storage durations, the integration of thermal energy storage (TES)

Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call