Abstract
The most commonly used structural materials for blades and other high temperature components of gas turbines are nickel base superalloys. A TBC protection coating system consists of a top coat of yttria partially stabilized zirconia and an underlying bond coat, usually MCrAlY (where M stands for Ni, Co or a combination of both). MCrAlYs are normally deposited by the thermal spray processes: air plasma spray (APS), vacuum plasma spray (VPS/LPPS) or high velocity oxygen fuel (HVOF). The adhesion between the bond coat and the substrate, and therefore of the whole thermal barrier system, strongly depends upon the surface roughness. A high level of roughness generally denotes better adhesion, especially with the HVOF thermal spray process where it is a necessity. Generally the roughness is reached by means of grit blasting with an abrasive media; this results in a certain level of surface contamination due to the entrapment of abrasive particles. The aim of this work was to set up a new surface preparation process in order to obtain a completely clean surface with a suitable roughness, which can be coated afterwards with HVOF or VPS/LPPS thermal spray technology. The tests carried out by this process on turbine blades, coated with a HVOF system, led to obtaining a coating/base material interface without any contamination caused by the surface preparation.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
