Excitation of atmospheric pressure uniform dielectric barrier discharge using repetitive unipolar nanosecond-pulse generator

Abstract

Dielectric barrier discharge (DBD) excitation by unipolar high voltage pulses is a promising approach for producing non-thermal plasma at atmospheric pressure. In this study, a magnetic compression solid-state pulsed power generator was used to produce repetitive nanosecond pulses for the excitation. The DBD is created using two liquid electrodes. The electrical characteristics of the discharge voltage and current are illustrated under different experimental conditions. The nanosecond-pulse discharge current is of the order of tens of amperes. This differs from common DBD current excitated by high-voltage ac sources. Compared with the characteristics of two current pulses corresponding to two discharges for unipolar pulsed-excitation, the secondary discharge in this study is minor owing to the pulsed power and discharge configuration. Under the experimental conditions, the luminous emissions from the front and side views of the liquid electrodes show that no filament is observed and the discharge is homogeneous and diffuse in the whole discharge region. The effects of applied voltage amplitude, repetition rate, and air gap spacing on the discharge characteristic are investigated. The discharge mode does not change with the variation of the investigated parameters. A comparison of high voltage ac and nanosecond-pulse excitation is also presented. In addition, discussion of the experimental results is presented.